The Best Carpentry Tips

For a beginner, handyman contractors can seem very difficult as it involves a lot of techniques and complicated skills. Fortunately, there are tips and tricks on carpentry that you can use to improve your woodworking skills. Most of these techniques were discovered by expert and seasoned carpenters after several years of trial and error.

So, if you’re new to house repairs and you want to do some woodworking, then use the starter points we have listed for you down below.

Don’t Measure Unless It’s Needed

When people do woodwork, there’s a need to measure and this is done using a good ol’ tape measure. When cutting down wood, you will cut on the mark that you placed after measuring. Yes, this works 8 out of 10 times. However, it’s very easy for a beginner at handyman to mismeasure and the mistake can be very expensive. What we recommend is that you just simply hold the wood or trim up. Then, mark the wood where it needs cutting. This will reduce your chances of making a mistake. If you really need to measure, then make sure to measure twice.

Remembering Measurements

When you use a measuring tape, you’ll find it difficult to remember what you measured every single time. You can avoid this problem by sticking a little piece of masking tape on one side of your tape measure. Now, you can jot down measurements using a pencil or pen.

Removing Nails

Using sharp nippers, pull nails out of a piece of wood by gripping their heads firmly. We recommend that you use sharp nippers instead of pliers as the latter will only cause damage to your woodwork.

Straight Claw Hammers

Most people use a curved claw hammer with woodworking as it’s the most common. However, this is not the best type of hammer. What you need is an all-around hammer, which is the straight claw hammer. It’s not just perfect for hammering but also for pulling nails. You can even use it to lift partition walls and doors. If needed, it can be used like a basic chisel.

More handyman services Tips and Advice

1. Don’t hold a hammer in a very tight grip. Loosen your grip just a little so the hammer can work better.
2. If you are using a nail, there’s a great chance that the hammer will hit your fingers. To avoid this, use a comb so its teeth will hold the nail instead of your fingers. Just make sure you get your comb out before you drive the nail down completely.
3. Hammer lightly until the nail is already in for about a third. This way, there’s less chance for you to send a nail directly into your face. Once it goes deeper than a third, then you can hit it harder.
4. Use canvas nail aprons to hold your supplies. They are inexpensive and very convenient. Whenever you need nails, you just simply reach down.
5. Avoid putting a nail through a knotty part of a wood. Knotty parts are rounder and darker compared to the other parts of the board. They are also tougher. If you drive a nail through them, you may split the wood in two.